First Stop Aquatics > Thermometers
PinPoint Wireless ThermometerUtilizing a radio wave signal, the remote sensor(s) will measure the temperature at the waterproof probe tip and send the information to the PINPOINT Temperature Display Monitor, which will display the temperature in Fº or Cº degrees. The PINPOINT Wireless Thermometer can accept a maximum of 4 remote sensors, thus expanding the monitoring capability to 4 different locations to be displayed on the same PINPOINT Temperature Display Monitor.* Given proper care, the PINPOINT Wireless Thermometer should last a lifetime.* Remote sensors can transmit temperature signals as far as 100 feet (30 Meters) in optimum conditions.* The monitor and remote sensor are powered by two AAA batteries each.* Monitor accepts up to four remote temperature sensors. * For more details, see Users Guide
Digital clock/thermometer with illuminating light. Accurate measurement of aquarium water or room temperature in F or C.Rainbow Lifegard/Pentair Aquatics Little Time & Temp Digital Clock and Temperature Indicator with backlit display and battery. Features digitally correct readings of aquarium water or room temperature. Perfect for Aquariums, Reptiles or Greenhouses Includes Illuminating backlit display Safe for Salt or Freshwater Use Attaches to any surface 3` Cord with all plastic probe & suction cup Battery included two year lifetime Wide temperature range (-58°F to 158°F) 1-Year Warranty.
100% reef safe plastic probeCompletely Uk spec and CE approvedThe ATC 300 2 channel temperture controller is a must have unit if you use heaters in your tank. Every year more tanks are wiped out by faulty heater thermomstats than any other failure.The ATC 300 works by monitoring the tanks temperature independantly and will switch off your heater directly if the tank temperature goes above your pre set value enabling you to have complete control over your heaters function. Whats more the unit is design to fail safe and comes with failure alarm and also over heating alarm if your tank does reach its pre set heat valueWith the built in timer function you can also run pumps fans or many other devises to come on and off at set intervals i.e 1 hour on, 2 hours off etc.SpecificationsPanel size:150 x 84(mm)Product size:150 x 84 x 45(mm)Power supply:220VAC +/-10%Power consumption : 3WTemperature controlling range:16-+36 oCTemperature measuring range :0-+50 oCResolution: 1Accuracy: +/- 1 oCTiming cycle :24 hoursControlling load: 1200W/220VAlarm when exceeding temperature limit: +/-3 oCSensor type: NTC
The ATC800 dual mode temperature controller is an all in one package that not only controls the heating of your aquarium/enviroment but also the cooling.To operate the unit just wire your heater and cooling equipment into the ATC800 and set you desired temperature, then simply set up your differential temperature (the amount you wish the controller to go above or below your set value before switching on either devise) and then let the unit automate your aquarium/enviroment automatically.the ATC800 is fitted with a fail safe circuit in case of sensor failure, and the cooling circuit has a built in 3 minute delay between switching to protect any chiller compressor from continued switchingFully salt water safe probe - ideal for marine reef use as well as all fresh water enviromentsthe unit is of a panel mount design and requires mounting in a suitable boxSpecSize ~ 180x100x54cmOperating temp ~ -5 - +70 degree CPower ~ 220V ACAccuracy +/- 1 degree CSensor ~ NTCRelay ~ cooling - 25amp maxRelay ~ heating - 10amp maxCooling delay ~ 3 minutes
