ATC800 Digital Heater - Cooler Controller

The ATC800 dual mode temperature controller is an all in one package that not only controls the heating of your aquarium/enviroment but also the cooling.

To operate the unit just wire your heater and cooling equipment into the ATC800 and set you desired temperature, then simply set up your differential temperature (the amount you wish the controller to go above or below your set value before switching on either devise) and then let the unit automate your aquarium/enviroment automatically.

the ATC800 is fitted with a fail safe circuit in case of sensor failure, and the cooling circuit has a built in 3 minute delay between switching to protect any chiller compressor from continued switching

Fully salt water safe probe - ideal for marine reef use as well as all fresh water enviroments

the unit is of a panel mount design and requires mounting in a suitable box

Spec

Size ~ 180x100x54cm
Operating temp ~ -5 - +70 degree C
Power ~ 220V AC
Accuracy +/- 1 degree C
Sensor ~ NTC
Relay ~ cooling - 25amp max
Relay ~ heating - 10amp max
Cooling delay ~ 3 minutes